Broan BR283003 Guia de Instalação descarregar pdf (Página 4)

3. Remove switch cover from right end of air vent.

4. Loosen the 2 screws holding the switch bracket in place.

Position switch bracket so that activating switch just comes in

contact with underside of switch membrane. Tighten screws.

5. Replace switch cover, gently lower air vent into chimney, and

plug in power cord. Re-connect electrical power and check

operation.

WIRING DIAGRAM

SWITCH

COVER

SCREWS

SWITCH

MEMBRANE

SWITCH

BRACKET

INSTALL COOKTOP

1. Align the cooktop with the downdraft and fasten cooktop in

place.

Note: Accurate alignment of cooktop and downdraft is necessary

to ensure that there is no interference when air vent is raised and

lowered. There should be a gap of 1/32"-1/16" between the back

of the cooktop and the front of the downdraft cover.

ADJUSTMENT

The downdraft is factory-adjusted for proper operation. However,

shipping and handling may affect the position of the activating

switch.

To adjust position of activating switch:

1. If downdraft is plugged into electrical outlet, unplug it.

2. Lift air vent straight up and cock it slightly so it remains in the

UP position.

WARNING: To avoid possible electrical

shock, personal injury or death -

Disconnect electrical power.

USE AND CARE

Always turn the downdraft blower on before you begin cooking to

establish an air flow in the kitchen. Let the blower run for a few

minutes to clean the air after you turn the cooktop off. This will

keep the whole kitchen cleaner and brighter.

CONTROLS

Turn the downdraft blower OFF by pressing the activating switch

again. The air vent will go down and the blower will shut OFF.

Note: For most convenient operation, set the blower to your

favorite speed. The blower will come on to this speed whenever

the activating switch is pressed and the air vent rises.

The blower can be turned ON or OFF and its speed can be

adjusted with the recessed knob on the right side of the air vent.

KNOB

Turn the downdraft blower ON by pressing down on the activating

switch. The air vent will rise.

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Broan BR283003 Guia de Instalação Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com não Broan BR283003