Broan 523002 Manual de Utilização e Manutenção descarregar pdf (Página 2)

PLANNING DUCTWORK

INSTALLATION

Begin planning ductwork by deciding where the duct will run be-

tween the range hood and the outside. For best performance, use

the shortest possible duct run and a minimum number of elbows.

5” ROUND DUCT

MODEL P85

DAMPER

ROOF CAP

Straight up through the roof using 5” round duct (for single story

installations only). Use a Model P85 5” round damper (sold

separately).

Ducting between the ceiling joists (for multi-story installations) or

through the soffit space above the cabinets (where the soffit connects

to an outside wall).

5” ROUND

DUCT

ADJUSTABLE

ELBOW

WALL CAP

PREPARE THE HOOD

1. Unpack hood and check contents. You should receive:

1 - Aluminum Filter

2. Remove wiring box cover. Under cover find:

1 - Plastic Bag containing loose mounting hardware

PREPARE THE

INSTALLATION LOCATION

Omit STEP 1 if hood will be installed under cabinets with flush

bottom.

3. Remove top or rear electrical knockout.

4. Install Model P85 damper over opening in top of hood. Use three

(3) screws provided with damper.

1. (For installation on recessed bottom cabinets only) Attach a

wood filler strip at each side of recessed area under cabinet.

Use two 1” x 2” strips cut to length. If recess is deeper than 1”

use thicker strips. Attach strips with 1-1/4” wood screws, 3” from

each end of strip.

Optional: Attach wood filler strips under front and back of cabinet

and use additional 3/16” diameter mounting holes in hood.

1 2 3 4 5 6 7 8

Sem comentários

Broan 523002 Manual de Utilização e Manutenção Página 2